mAINTENANCE
WARNING
CORGHI declines all liability for claims de-
riving from the use of non-original spares or
accessories.
WARNING
Before making any adjustments or performing
maintenance, disconnect the electrical supply
from the machine and make sure that all moving
parts are suitably immobilised.
Do not remove or modify any parts of this
equipment except in the case of service in-
terventions.
CAUTION
Keep the working area clean.
Do not clean the machine with compressed air
or jets of water.
When cleaning, take care to avoid creating and
raising dust as far as possible.
Never use solvents to clean the aligner or
targets.
- Store the targets carefully in a dry place, to
avoid loss of calibration with consequent
measurement inaccuracy.
- Calibrate the targets at least once every six
months.
- Keep the target mounting clamp guides
clean.
- Keep the turntables and the oscillating
footboards on which the vehicle alignment is
performed perfectly clean and do not oil or
grease them.
Floppy Disk Driver maintenance
with use, floppy disk drivers can become dirty
and when they are used to read the floppy disks,
they can damage them or may not be able to
read them correctly.
Use a cleaning kit periodically (at least once a
month) and each time a new update is installed
before starting the installation procedures.
SCrAPPING
If the machine is to be scrapped, remove all
electrical, electronic, and plastic components
and dispose of them separately, as provided for
by local legislation (See fig. 67 and 68).
76
Eichstädt Elektronik - Professionelle Kfz-Diagnosegeräte
http://www.eichstaedt-elektronik.de
ENVIroNmENTAL
INFormATIoN
The disposal procedure described below must
only applies to machines with the symbol of
the waste bin with a bar across it
their data plates.
This product may contain substances which may
cause damage to the environment and human
health if not disposed of properly.
we are therefore providing you with the informa-
tion below in order to prevent these substances
from being released into the environment, and
to improve the use of natural resources.
Electrical and electronic equipment must not
be disposed of with ordinary municipal waste;
it must be disposed of separately by authorised
facilities.
The symbol of the waste bin with a bar across it,
which appears on the product and on this page,
reminds users that the product must be disposed
of properly at the end of its working life.
This prevents the inappropriate disposal of
the substances which this product contains, or
the improper use of some of them, from having
hazardous consequences for the environment
and human health. It also helps to ensure the
recovery, recycling and reuse of many of the
materials these products contain.
To allow this, the producers and distributors of
electrical and electronic equipment organise
special systems for the collection and disposal
of such equipment.
At the end of the product's working life, contact
your dealer for information about disposal
procedures.
when you purchase this product, your dealer will
also inform you that you may return another worn-
out appliance to him free of charge, provided it
is of the same type and has provided the same
functions as the product just purchased.
Anyone disposing of the product otherwise than
as described above will be liable to prosecution
under the legislation of the country where the
product is scrapped.
Operator's manual EXACT BlackTech X
on