Automatic Stop - Krups KM468950 Mode D'emploi

Français English
W hen the cycle is finished, press the safety button (B) and simultaneously raise the locking lever (A)
n
GENTLY to release any residual pressure . Fig. 11 Remove the glass carafe .
Attention: Do not touch the stainless steel machine parts: the water tank (G) and the lid of the
permanent filter (C). You are likely to burn yourself especially when pouring the coffee.
F rom time to time, the coffee may appear cloudy . This may be due to water quality, type of ground coffee
n
used or ground fineness . We recommend that you stir the coffee in the carafe .
I f the coffee cycle takes significantly more time than usual, please carry out a descaling cycle . (see
n
DESCALING section) .

AUTOMATIC STOP

Y our device will automatically turn off approximately 20 min after the beginning of a cycle .
n
STORING THE POWER CORD
For more convenience, your coffee maker is equipped with a storage space for the cord . It is located at the
base of the unit . Fig. 12
CLEANING
N ever immerse the body of the appliance in water . Always unplug and allow the appliance to cool down
n
before cleaning .
T he water tank (G) and heater are made of stainless steel and therefore are easy to clean .
n
C lean the water tank (G) with a soft cloth or wet sponge . Do not clean the appliance when it is still hot .
n
D o not attempt to remove scale with abrasive objects or materials; they can be lodged in the pipe and
n
the plug (see the DESCALING section) .
W ash the glass carafe (E), lids (C and F) and permanent filter (D) using hot water and mild dish detergent
n
then rinse thoroughly and carefully .
I f needed, loosen the screw located at the bottom of the lid of the permanent filter (D) and clean the
n
interior of the lid . Fig. 13 and 14
REPLACEMENT OF THE GASKET
A fter a certain period of use, the lid of the water tank (F), the permanent filter (D) or hot water pipe may
n
no longer close properly . This is due to the deterioration of the gasket . To replace them, contact an
Authorized KRUPS Service Center .
DESCALING
W hy descaling
n
Scale is naturally formed in your coffee maker . Descaling preserves the coffee maker, ensuring a longer life
of the appliance and a consistent quality of coffee every single time . Scale may permanently deteriorate the
performance of the machine . Machine malfunctions related to scaling will not be covered under warranty if
you return the product .
W hen to descale
n
The frequency of descaling depends on the water hardness and the number of coffee cycles . Longer
brewing time, high evaporation, high level of noise at the end of cycle, stops during the cycle, each of these
signs show that descaling is necessary.
The descaling of the coffee maker must be done once the machine has gone through 20 to 40 cycles or
once a month depending on the water hardness .
12