KPS -MT10 Manuel D'instructions page 13

KPS-MT10 • Digital multimeter
5. OPERATING INSTRUCTION
DC Voltage measurement
1. Set the function switch at V position.
2. Connect test leads across the source or load under
measurement. The polarity of red lead connection will be
indicated at the same time as the voltage value.
AC voltage measurement
1. Set the function switch at V ~ position.
2. Connect test leads across the source or load being
measurement and read the voltage value on the LCD dis-
play.
DC current measurement
1. Set the function switch at A position.
2. Open the circuit in which the current is to be measured
and connect test leads in series with the circuit.
3. Red current value on the LCD display along with the
polarity of red lead connection.
AC current measurement
1. Set the function switch at A ~ position.
2. Open the circuit in which the current is to be measured,
and connect test leads in series with the circuit and read
LCD display.
Resistance measurement
1. Set the function switch at Ω position. (Note: The polar-
ity of red lead is positive "+").
2. Connect test leads across the resistor to be measured
and read LCD display.
3. If the resistor being measured is connected to a circuit,
turn off the power of the circuit and discharge all capaci-
13