Pre-Operation Inspection - RIDGID KJ-2200 Mode D'emploi

KJ-2200/KJ-3100 Water Jetting Machines
Figure 5 – KJ-3100 Handle Assembly

Pre-Operation Inspection

WARNING
Before each use, inspect your water jetter and cor-
rect any problems to reduce the risk of serious in-
jury from high pressure water and other causes
and prevent jetter damage.
Always wear safety glasses, gloves and other ap-
propriate protective equipment when inspecting
your jetter to protect against chemicals and bac-
teria on the equipment.
1. Make sure that the engine switch/key is in the OFF
position.
2. Clean any oil, grease or dirt from the equipment, in-
cluding the handles and controls. This aids inspection
and helps prevent the machine or control from slipping
from your grip.
3. Inspect the water jetter and accessories for the fol-
lowing:
• Proper assembly and completeness
• Broken, worn, missing, mis-aligned, binding or
loose parts
• Presence and readability of the warning labels.
(See Figure 6)
• Any other condition which may prevent the safe
and normal operation
If any problems are found, do not use the water jetter
until the problems are corrected.
6
T-Knobs
Insert Figure 6A – KJ-2200 Warning Labels
Hair Pin
Figure 6B – KJ-2200 Warning Labels
Figure 6C – KJ-3100 Warning Labels