Zibro P 622 Manuel D'utilisation page 72

I
TROUBLE SHOOTING
Problem
The unit does
not function.
The unit does
not seem to
perform.
The unit is noisy. Unit stands uneven.
The compressor
does not work.
Remote control
does not
function.
Never try to repair or dismantle the air conditioner yourself. Incompetent repairs
result in loss of warranty and can endanger the user.
J
GUARANTEE CONDITIONS
The air conditioner is supplied with a 24-month guarantee, commencing on the
date of purchase. All material and manufacturing defects will be repaired or
replaced free of charge within this period. The following rules apply:
1.
2.
3.
4
72
Cause
No power supply.
Is the LCD light flashing.
Timer function is active.
Internal watertank is full.
In direct sunlight.
Windows or doors open, many
people or heat sources in room.
Dirty filter.
Air inlet or air outlet blocked.
Room temperature lower than
selected value.
Overheat protection probably
activated.
Distance too big.
Remote control signal not
detected by control panel.
Batteries empty.
We expressly refuse all further damage claims, including claims for collateral
damage.
Repairs to or replacement of components within the guarantee period will
not result in an extension of the guarantee.
The guarantee is invalidated if any modifications have been made, non
genuine parts are fitted or repairs are carried out by third parties.
Solution
Connect to a functioning outlet
and switch on.
Empty the internal water
container (refer to Chapter E).
De-activate Timer function (refer
to Chapter C).
Empty internal watertank (refer
to Chapter E).
Close curtains.
Close doors and windows, or
place an extra air conditioner.
Clean or replace filter (refer to
Chapter D).
Remove blockage.
Change temperature selection.
Place on even surface (less
vibrations).
Wait 3 minutes until the
temperature has decreased, and
turn on the unit again.
Make sure the remote control is
correctly aimed at the control
panel.
Replace the batteries.