Remote Control - Zibro P 622 Manuel D'utilisation

E
EMPTY INTERNAL WATER CONTAINER
Under extreme (humidity) circumstances it may be necessary to empty the internal
water container. When the internal water container is full the backlight on the
LCD-display will be flashing. The unit will switch off automatically. To empty the
water container do the following:
1
2
3
4
5
F

REMOTE CONTROL

The unit responds to all signals that are sent by the remote control
be a beep sound from the unit after receiving the signal. The operation of the
unit (see chapter C) by remote control, is almost identical to the operation by the
circular control panel.
The only exception is the clock function.
Instead of the common
gramming the timer, there are 3 push buttons on the remote control as follows:
•
•
•
4
70
Switch off the unit and remove the plug from the wall socket.
Do not move the unit. Doing this can result in water leakage, damaging your
floor or carpet.
Place the water container
drainage point µ.
Remove the water stopper µ and rubber plug from the drain and let the
water run out. The water container has to be emptied several times before all
water will be drained (ca. 1,5 ltrs).
Replace the rubber plug and water stopper µ, put the plug into the wall
socket, and switch the unit on. The warning signal should be off.
NOTE!
When the air conditioner is in use, under normal circumstances the
condensed water will be discharged through the hot air outlet-hose ¸.
push button for setting the actual time and for pro-
- for setting the actual time
TIMER ON - for programming the time for the unit ON
TIMER OFF - for programming the time for the unit OFF
on the floor underneath the permanent
. There will