Zibro P 622 Manuel D'utilisation page 64

C
88: : 8 8 8 8
8 8 8 8 : : 88
4
64
Fit the telescopic slide bar
7
slidebar connector
window or door as much as possible to prevent outside air entering the
room. Ensure that the slidebar connector
IMPORTANT
The flexible exhaust hose can be extended from 500 to 1500 mm for
mounting.This length has been designed especially according to the
specifications of the air conditioner. Do not use an extension or
exchange for a different hose as that may lead to malfunctioning. The
exhaust air must flow freely, any blockage can lead to overheating of
the air conditioner. Take care to prevent any sharp bow or bend in the
exhaust (see pictures).
OPERATION
1. CONNECTING TO THE MAIN
Insert the plug in the wall socket. Then press
buzzer will beep, and the LCD will display 12:00 o'clock as default.
2. SETTING THE CLOCK
Press the push button for 3 seconds to set the clock. The 2 left digits of the
1
4 digits on the LCD-display will flash.
Press or to adjust the hour.
2
3 Press momentarily, the 2 right digits of the 4 digits will flash.
4 Press or to adjust the minutes of the clock.
Press the push button for 3 seconds again to activate the clock.
5
3. TEMPERATURE SETTING UP/DOWN
If you want to change the set temperature press
The 2 digit display will indicate the set temperature.
NOTE
Reaching the set temperature is up to surrounding room conditions.
to the window and adjust the length. Put the
in the opening in the telescopic slide bar. Close the
has a free flow outside.
to switch the unit on or off. A
or to set the temperature.