Front View; Remote Control; Description Of Parts - LENCO DR-05 BT Guide De L'utilisateur

Front View

STANDBY TREBLE BASS
No.
Components
1
Standby
2
Treble
3
Bass
4
Volume knob
5
Display screen
Bluetooth indicator
6
Remote control sensor
7
Tuner knob/ Enter
8
/ BT Pair
9
Source
Menu/Information
10
Next
11
Previous
Scan
Preset
12
Play/Pause

Description of parts

VOL
Description
Tap this button up or down to turn the unit on, or to
the standby mode.
Tap up or down to enter the treble setting interface and use
the volume knob within 3 seconds to adjust the treble level
to get a vivid sound effect.
Tap up or down to enter the bass setting interface and use
the volume knob within 3 seconds to adjust the bass level
to get a vivid sound effect.
Adjust the volume to a comfortable level.
Display source frequency, and playback information.
Indicates the mode status.
Point the remote control to this sensor.
In DAB mode, rotate to skip to next or previous stations.
In FM mode, tune the frequency up or down by steps of 0.05MHz.
In menu status, press ENTER to confirm selection.
When the buzzer alarm goes on, press ENTER to stop the alarm.
or rotate the Tuner knob to enter the nap mode,the alarm will go
on 5 minutes later.
If you want to disconnect the paired devices, press BT PAIR
button to disconnect and the unit enters the BT pairing status.
Then use the phone device to make connection
Press repeatedly to select the source you want: FM, USB,
BLUETOOTH(BT), AUX IN, DAB.
In DAB or FM mode, long press to enter the setting menu.
In DAB mode, press briefly to cycle through the station information.
In BT mode, press Next button to skip to next track.
In standby mode, press to enter the time and alarm setting.
In FM mode, press repeatedly to cycle through the radio information.
In BT mode, press to skip to previous track.
In FM mode,press to scan the available stations.
In radio mode, use Preset button to store favorite stations.
In BT mode, press to pause the playback, press again
to resume playing.
4
9
10
TUNER / ENTER/ BT PAIR
SOURCE
INFO/MENU/
PRESET/
SCAN/
8
11
12
.