Protac SenSit Mode D'emploi page 14

Dismantling instructions before wash:
1. Take the neck pillow out of the neck compartment.
2. Seat zips off.
3. Loosen the inner shell with balls using the back Velcro.
4. Unzip the components with front and back foam plates.
5. Remove the ballbags from both neck wings (two bags).
6. Remove the inner shell.
7. Remove the back foam plate.
8. Remove the front foam plate.
9. Remove the ball bags from the side wings (two bags). The balls are washable, use the
DK
enclosed laundry bag.
10. All zippers should be zipped up before the chair cover is washed.
GB
Assembly after wash:
1. Unzip the seat cover.
2. Spread out the chair cover so Velcro on the inside of the bottom of the cover is visible.
DE
3. Unzip the front foam cushion compartment.
4. Place the foam cushion in the compartment. Fold in both sides of the cushion when fitting
– it can be smoothed out again once it is in place.
FI
5. Zip the compartment.
6. Unzip the compartment for the rear foam cushion.
7. Place the foam cushion in the compartment – remember the hard plastic side must face
FR
inwards. Again, fold both sides of the foam cushion to ease placement.
8. Zip the compartment.
9. Position the inner bag in the cover so that the Velcro tapes meet at bottom and back.
NL
10. Zip the seat cover. Remember to affix the Velcro on seat cover to the Velcro on the inner
bag (in the centre, close to the rear bag).
11. Place the neck cushion and neck wings into the compartments and zip. Remember to
SE
secure the neck wings with Velcro.
12. Place side wings (the 2 large bags with plastic balls) into the cover and zip.
ES
Find videofilm showing how to assemble the SenSit chair at: www.protac.dk
IT
Please note! This is a job for two people!
14