Chapter 5 Operation; Play A Cassette; Fast-Forward And Rewind - X4-TECH TP-1000 Mode D'emploi

(6) REC LEVEL control
This control serves for adjusting the signal gauge when recording (only active when re-
cording external audio sources, when recording with deck A the recording will automati-
cally be rejected.
() Recorder buttons
=REC: Press this button at the same time with button 6 (PLAY) to start the recording.
4PLAY: Press this key for replay.
7 REW: Press this key to rewind the cassette.
8FF: Press this key to forward the cassette.
</5 STOP/EJ.: Press this button once to stop the driving function, press again to open
the cassette case.
;PAUSE: Press this button to interrupt the replay or the recording shortly. By pressing
again the brake function will be switched off.
(8) Button REC CrO

Press the button to record to a CrO -Cassette.
2
(9) Button HI.SP.DUB.
With this button the fast copy function from deck A to deck B is activated (always only in
combination with the button DUBBING (10)).
(10) Button DUBBING
With this button the copy function from deck A to deck B is activated.
(11) Button PLAY CrO

Press the button to play a CrO -Cassette.
2

Play a cassette

› Playing cassettes is possible in both decks (A and B).
› Press the key POWER (1) to switch on the device.
› Press the 5/8 STOP/EJ button. The cassette compartment (2) opens.
› Put a recorded Cassette with tape opening downwards in the drive.
4 Chapter 5 Operation
› Close the drive.
› Select the Tape-input on your amplifier.
› If it is a CrO -Cassette, press the button PLAY CrO
2
control LED flashes on the display (4) above the button.
› Put the switch NOISE REDUCTION (3) into the correct position for this cassette.
› The cassette was recorded with the hissing reject system > put switch to ON.
› The cassette was recorded without the hissing reject system > put switch to OFF.
› Press the key4PLAY.
› The playing starts.
› Press the button;PAUSE to interrupt the replay shortly. To continue replay press button;PAUSE
again.
› Press the button </5 STOP/EJ once, to stop the replay.
› Press the button </5 STOP/EJ again, to remove the cassette.
The replay ends automatically when the tape ends.

Fast-forward and rewind

› Before you can forward or rewind the cassette, you must end the replay with the button
</5STOP/EJ.
› Press this key 8 FF to forward the cassette.
› Press this key 7 REW to rewind the cassette.
› Press the button</5STOP/EJ, to stop the forwarding or rewinding.
› On deck B you can check the tape position with the tape counter (5).
(11). When the button is activated agreen
2

Chapter 5 Operation