Connecting The Power Supply - X4-TECH TP-1000 Mode D'emploi

› Connect the LINE PLAY (OUT) with the TAPE-input of your amplifier (often marked with TAPE IN
resp. TAPE PLAY).
› Connect the LINE (IN) REC with the TAPE-output of your amplifier (often marked with TAPE OUT
resp. TAPE REC).
› If you are using the HiFi amplifier A-100, connect the remote input REMOTE SYSTEM O AMP
with the corresponding remote socket REMOTE SYSTEM TAPE on the amplifier. You can then
control the cassette recorder with the remote system.

Connecting the power supply

Make sure that, before you connect device to the power supply grid, the operating
mode switch (1) is switched off (position "OFF").
The POWER (1) switch does not entirely disconnect the device from the electricity
supply. In order to completely separate the device from the electricity net, you have
to pull the mains plug out of the wall socket.
› Connect the mains plug of the cassette recorder to a socket (230 V~/50 Hz) linked to the public
power supply network.
 Chapter 4 Connection
Operation
1 2 3 4
LEVEL M ET ER IN DIC AT ION
N OIS E R EDUC TION
FW D
A DY N AM IC N O IS E RED UC TION
OF F ON
PLAY F U LL AUTO ST OP SYSTEM
PLAY C rO 2 D UBBIN G H I.SP.DU B.
PO WE R
ON O FF
PLAY R EW F F STOP/EJ. PA USE
7 11 10 9
(1) POWER button
This button switches the Cassette recorder on and off.
Position ON > Device is on, alternatively in standby mode (when switched off by the ampli-
fier A-100 remote control)
Position OFF > Device is switched off.
() Cassette drives
Please put the cassette into the recorder. The device has two drives, deck A is for playing,
deck B is for playing and recording.
() Switch NOISE REDUCTION
Use this switch (shift it to ON) to activate the dynamic hissing rejection system.
(4) Display reading
This display shows the gauge of the signals when recording resp. playing and also shows
device conditions.
() Tape counter for deck B
With this Tape counter you can find certain tape points. Press the button beside the coun-
ter to set back to 100.

5 6 2
DEC K B C O UN TER
RE C LEVEL
FWD
H IGH S PEED DU BBIN G
B
RE C /P LAY FU LL AUT O ST OP SY STEM
MI N MAX
RE C CrO2
RE C P LAY REW FF S TOP/EJ. PAUSE
8 7
Chapter 5 Operation