Scope Of Delivery; General Information; Reading And Keeping The Instructions For Use; Explanations Of Symbols - Craft Meyer 10002556 Mode D'emploi

CHAIN BREAKER AND RIVETER

1 | Scope of delivery

1
3
8
1 Stop holes 5
Alignment marks
2 6
A&B
3 Press-out hole 7
4 8
U-shaped bracket

2 | General information

2.1 | Reading and keeping the instructions for use

These instructions apply exclusively to the aforementioned chain
breaker and riveter. They contain important information on handling,
safety and warranty. Read the instructions carefully, in particular
the safety instructions, before using the chain breaker and riveter.
Failure to adhere to instructions can cause damage to the vehicle
and result in consequential damages or even an accident.
Keep these instructions for future reference. If you pass the
chain breaker and riveter on to third parties, you must also
hand over these instructions.
14
2
4
5
6
7
Riveting tip 9 Alignment pin
Breaking and
10 Body
riveting pin
Breaking tip 11 27mm
12
Plate holder 19 mm
The instructions for use are based on the standards and regulations
valid in the European Union. If abroad, observe country-specifi c
guidelines and laws.

2.2 | Explanations of symbols

The following symbols and signal words are used in these
instructions.
WARNING!
9
CAUTION!
10
11
12
NOTE!

3 | Safety

3.1 | Intended use

This chain breaker and riveter is designed to break D.I.D motorcycle
chains with the pitches 520, 525, 50(530) and 532, and to rivet
these chains using a D.I.D rivet link, type ZJ (tubular rivet). Check
whether the chain coupling is suitable for your chain prior to
assembly. Each chain type requires its own identical chain coupling.
Since this is a universal product and not intended just for one
particular vehicle, it is important to make sure that it is suitable for
your vehicle before you use the product for the fi rst time.
Always follow the instructions in your vehicle owner's manual and the
directions of the vehicle manufacturer. This is essential, as improper
use of this product or its unsuitability for a vehicle could impair the
safety of the vehicle and/or damage it.
Only use the chain breaker and riveter as described in these
This signal symbol/word indicates
a hazard with a medium risk level
which, if not avoided, may result in
death or serious injury.
This signal symbol/word indicates
a hazard with a low risk level which,
if not avoided, may result in minor
or moderate injury.
This signal word warns of possible
material damage.
This symbol gives you useful addi-
tional information about assembly
or usage.
15