Filling The Water Tank; Using The Appliance - TEFAL IS3300 Mode D'emploi

2 • Filling the water tank
Dear Customer,
Before delivery we undertake a quality control check on garment steamer. This garment
steamer has been checked so a small residue of water may be left in the water tank. This
garment steamer has passed the quality control check.
IMPORTANT: Your product is designed to operate using untreated tap water. If your water is
very hard (check with your local water authority) it is possible to mix untreated tap water with
store-bought distilled water in the following proportions 50% untreated tap water with 50%
distilled water. Heat concentrates the elements contained in water during evaporation. The
types of water listed below may contain organic waste, mineral or chemical elements that can
cause spitting, brown staining or premature wear of the appliance: water from clothes dryers,
scented or softened water, water from refrigerators, batteries, air conditioners, rain water,
boiled, filtered or bottled water. These types of water should not be used. Only use store bought
distilled water as advised above.
• Ensure that the appliance is unplugged. Open the water tank filling inlet, fill it with water and
close it. (fig. 10, 11 & 12)
USE
Warning: Never steam a garment while it is being worn.
1 • Setting up
The flexible hose and the end of the steam head can become extremely hot during
use. This is perfectly normal. Be careful and avoid any prolonged contact.
• Only operate the appliance on a floor clear of any materials which may obstruct the base of
the steamer (flat and horizontal surface). Do not obstruct the openings on the lower part of the
appliance. This appliance should not be used on very thick carpets or rugs.
• Undo the tie and completely unwind the electrical cord.
• Plug in to power socket.
• Switch on by pressing the ON/OFF button located on top of the appliance.
• The appliance will begin producing steam after approximately 60 seconds.
2 • Using the appliance
• Hang the garments on the integrated hanger or on separated hanger which may be suspended
on the hanger holder.
• To steam trousers, we recommend that you also use the support with clips*.
• Hold the steam head with the steam vents pointing away from you.
• Start steaming garment lightly following the grain of the garment fabric.
• Start at the top of the garment and gradually move downward.
• Always use the steam head in a vertical position.
Always be careful not to touch the hot steam.
* depending on model
(fig.13)
(fig.14)
EN
7