Assembly:
• Remove the Press & Steam vertical support from its pouch.
• Make sure the telescopic pole is fully extended.
• Hold the Press & Steam vertical support so that the handle is located downward and its
"Press & Steam" logo is in front.
• Insert the upper part inside the integrated hanger, then pull down slightly until hooking the
handle on the Press & Steam vertical support hook located on the pole.
• The Press & Steam vertical support helps keep the garment in place while steaming.
• When steaming a shirt, begin with steaming the sleeves. Take hold of one sleeve and cross
it over the garment using the Press & Steam for vertical support.
2 • Fabric brush*
• Remove the fabric brush once unit is unplugged and completely cool. Remove it by pressing
on the release tab on top of brush while pulling it forward.
3 • Lint pad*
• To use the lint pad, slowly brush the clothing with the grain or nap of the fabric.
• The pad can be cleaned by brushing it in the opposite direction. We recommend cleaning
the pad on an old cloth that can be discarded.
• We recommend to use the lint pad before steaming your clothes for perfect results.
4 • Glove*
* depending on model
The lint pad is a separate accessory and cannot be attached to
the steam head.You can use the lint pad independently from the
appliance.
The lint pad removes hair, lint and animal fur for a professional finish.
• The glove protects your free hand from the steam during use.
• To use the glove, put it on the hand you use to hold or pull the garment.
(fig. 20)
The glove should be only used with this garment steamer and not
for other purpose. Do not wash or iron the glove.
(fig. 15)
The fabric brush opens the weave of the fabrics
for better steam penetration.
• Attach the fabric brush to the steam head,
on cold appliance by lining up the bottom of
the brush with the bottom of the steam head.
Gently push the top of the brush onto the steam
head until it clicks into place.
• Gently brush the area to be steamed following
the grain or nap of the fabric.
(fig. 16-17)
(fig. 18)
(fig. 19)
(fig. 21)
EN
9