Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
CAUTION: Remove these batteries from the compartment when the
tool is to be stored without use for more than a few days. If left in, the
batteries may leak and damage the laser device. Damage from leaking
batteries is not covered under the warranty.
ADJUSTMENTS
WARNING! To reduce the risk of injury, keep pulley cover in place and
in proper working order when operating.
SPEED AND BELT TENSION
ADJUSTMENT
SELECT THE SPEED
1. The material you are drilling into and the size of hole you are planning to
make should determine the speed at which you set the drill press. As a
rule of thumb, small drill bits require more speed than large drill bits and
soft materials require more speed than hard ones.
Speed range
2000 to 3100 rpm
3/8"
1400 to 2000 rpm
5/8"
1000 to 1400 rpm
7/8"
800 to 1000 rpm
1-1/4"
530 to 800 rpm
1-5/8"
* These speeds are only general guides and vary further according to the
particular material you are working with (the kind of wood, for instance),
the type of drill bit or cutter you are using, any lubricants you may use and
the quality of the cut desired.
1. Select the speed by moving the belt to the appropriate pulleys. Open the
belt / pulley cover (V, fig 4 & 5)
2. Consult the belt position / speed diagram.
rpm: 260 tr/min rpm: 340 tr/min rpm: 390 tr/min rpm: 500 tr/min
rpm: 580 tr/min rpm: 630 tr/min rpm: 750 tr/min rpm: 790 tr/min
rpm: 870 tr/min rpm: 1040 tr/min rpm: 1590 tr/min rpm: 1740 tr/min
rpm: 2320 tr/min rpm: 2530 tr/min rpm: 2910 tr/min rpm: 4220 tr/min
3. Loosen the belt tension lock knobs; one on each side of the drill press
head.
4. Turn the belt tensioning handle (Y, fig 5) clockwise. This will pull the
motor forward, closer to the drill press head; bringing the motor pulley
closer to the spindle pulley, allowing the drive belts to be slipped on.
5. Choose the best speed for the drilling operation planned and install the
belts in the correct position on the pulleys to produce that speed.
APPROXIMATE RECOMMENDED DRILLING SPEEDS*
Wood
Aluminum / Zinc / Brass
9.5 mm
16 mm
11/32"
22 mm
15/32"
31.75 mm
11/16"
41.4 mm
DP2003 belt & pulley label
145 x 58 mm R=2.5
Non-ferrous metals
Drill bit diameter
7/32"
5.6 mm
8.75 mm
12 mm
17.5 mm
3/4"
19 mm
!
!
Iron & Steel
3/32"
2.4 mm
5/32"
4 mm
1/4"
6.4 mm
3/8"
9.5 mm
5/8"
16 mm
141219
15
Publicité
Table des Matières
