Technical Specifications; Maintenance And Inspection - Weber Rescue Systems STABFAST MK2 ALU Manuel D'utilisation

12 | English
IMPORTANT
The owner of the system must ensure that the StaBFast
who have read and understood these instructions for use. In order to ensure safe and effective use of the
StaBFast MK2 ALU stabilisation system, it is important to regularly familiarise yourself with the use and operation
®
of the system. All valid health and safety regulations must be taken into account when using the StaBFast
ALU stabilisation system. Keep these instructions for use together with the StaBFast
system.

Technical specifications

Stabiliser strut
Collapsed length:
Maximum extended length:
Weight:
Maximum load in longitudinal direction of strut (vertical):
Straps
Length of yellow, green and blue strap:
Maximum load:
Hook
Maximum load:
Adjustable wedge
Length x width:
Height adjustable:
Weight:
Maximum load:

Maintenance and inspection

Whole system
Clean with a soft brush and a dry cloth. Inspect visually for damage.
Straps
Clean with a soft brush.
Inspect visually for damage.
In case of doubt, or if torn, replace strap.
Hook blade
Sharpen point if necessary.
Maintenance and inspection
Whole system
Treat moving parts with silicon spray (as regards the pneumatic cushioning – introduce a few drops of lubricating
oil via the telescope).
Maintenance and inspection
Stabiliser struts, wedge and straps
Have checked in accordance with valid regulations for checking lifting and hoisting gear.
Replace all damaged and defective parts immediately with original parts. Treat corrosion immediately.
MK2 ALU stabilisation system is only used by persons
®
107 cm
172 cm
7.1 kg
15 kN
6 m
20 kN
25 kN
60 x 10 cm
6 – 20 – 27 cm
4 kg
7.5 kN
After every use
Every three months
Annually
MK2
®
MK2 ALU stabilisation
®