TEC 1050 Mode D'emploi page 4

Plug in the power cord  in
order to supply base station
 with mains power. Green
diode will light up.
Insert gun into contact slots
on base station . Glue will
now be heated up. Status
indicator: RED: heating up
(approx. 10-13 minutes).
Important Information
4
Detach heating head from
handle. To do this, release
bayonet catch by pulling
trigger  and turning heating
head. Insert sealed cartridge
into heating head .
Status indicator; GREEN:
Glue has reached bonding
temperature. Remove hot
melt glue gun from base
station .
 Un-sticking cartridge screw cap. If you are unable to remove the
screw cap with your bare hands after several times of use
because it has become stuck, it can be released using the
receptacle in the base station (see diagram). Important: You
must first heat up the hot melt adhesive in the base station.
 Always seal cartridge firmly when heating and after use.
 Before heating a new cartridge, allow heating head to cool down.
 If cartridge and heating head accidentally stick together, they can
be separated again after they are warmed up. Clean glue residue
from heating unit.
Reassemble heating head
and handle. This is done by
retracting feed rod  and
turning bayonet catch so that
is clips into place.
Unscrew cap  (store in
handle ). Pull trigger to
commence gluing. Feed rod
will advance and press
against cartridge piston. Glue
will emerge from nozzle.