TEC 1050 Mode D'emploi page 3

Operating Instructions
GB
Congratulations on purchasing your new TEC 1050 hot melt glue gun and thank you for the
confidence you have shown in us. You have chosen a high quality product that has been
manufactured, tested and packed with the greatest care. Please familiarise yourself with these
instructions before attempting to use the glue gun The greater the care you take in handling your
new product, the longer it will continue to provide reliable service.
Safety Warnings
 Carefully read through the operating instructions before using the glue gun.
 The hot melt adhesive reaches a temperature of 130°C. Caution: burn hazard. If glue comes into
contact with skin, immediately hold affected area under cold running water for several minutes.
Do not attempt to remove glue from skin first. In case of emergency, consult a doctor.
 Wear suitable gloves when working with the glue gun.
 Keep out of the reach of children.
 Only apply heat (130°C. using hot air gun) to remove glue in well ventilated rooms.
 Sensitisation may occur as a result of inhalation or contact with the skin.
 Immediately consult a doctor in the event of accident or queasiness.
Description

feed rod

power cord

heating head
Technical Specifications
Mains Voltage:
Output:
Heat-up time:
Operating temperature:
Cartridge content:
Mounting base station in fixed position.
If you wish, you can mount the base station on a firm base surface: Two recessed holes are
provided underneath the base station for this purpose: Spacing between screws (Ø2.9mm): 38mm.

compartment for storing
cartridge cap

base station with status
indicator
220-240 V, 50 Hz
14 W, starting phase (500 W)
10-13 mins
130°C
50g

trigger

screw cap
3