Electrolux EXP09CN1W5 Manuel D'utilisation page 10

10 www.electrolux.com
Mount wall adaptor directly over
correctly installed duct to outside. (This
usually includes aluminum wall ducting
& an outside cover. See your hardware
specialist for correct installation.) Use
wall plugs & screws to secure. (Fig. 10)
Attach hose duct to wall adaptor.
Fig. 10
The hose can be extended from
its original length of 38.1cm up to
139.7cm, but it is the best to keep the
length to minimum required. Also make
sure that the hose does not have any
sharp bends or sags. (Fig. 11)
Fig. 11
Installation in a double-hung
sash window
1. Cut the foam seals(adhesive type) to
the proper lengths and attach them
to the window and stool. (Fig. 12)
Fig. 12
Wall Adaptor
Screws
Screws &
& Wall
Plugs
Foam seal A
Foam seal A
(adhesive type)
(adhesive type)
2. Open the window sash and place
the window slider kit on the window
stool (Fig. 13). Attach the window
slider kit to the window stool. Adjust
the length of the window slider kit
according to the width of window.
Screw down the two screws on the
window slider kit. See Fig.13. Cut
the adjustable window slider kit if
the width of window is less than
26.6 inches (Fig. 14).
Max 48"
26.6"~48.5"
26.6"~48.5"
Mix 12"
Fig. 13
Fig. 14
3. Close the window sash securely
against the window slider kit. (Fig. 15)
4. Drive two 1/2" screws to secure
the window slider kit to the window
sash. (FIG. 15)
5. Secure the window slider kit to the
window stool (FIG. 15):
A: For wooden windows: Use 3/4"
B: For Vinyl-Clad windows: Use
3/4˝ screws or 1/2˝
3/4" screws or 1/2"
hex head cap screws
hex head cap screws
Fig. 15
screws
screws
Window slider kit Window slider kit
Window stool Window stool
Cut this side to fit your window
Cut this side to fit your window
screws for securing.
1/2" hex head cap screws for
securing.
1/2˝ screws
1/2" screws
Window slider kit Window slider kit
Window stool
Window stool