General Care - Drive Medical P682A/STD30DDAHTREV1 Mode D'emploi

so low that it causes uncomfortable pressure to thighs
at front of seat upholstery. Footrest should not be lower
than 2-1/2" from the ground to ensure clearance.
ADJUSTING/ELEVATING LEG REST
leg rest assembly to desired position. Release leg rest
assembly and it will automatically lock into place. To
lower, push out on leg rest lever and lower foot plate to
desired position.
- Large rear wheels should be inspected at
WHEELS
least once a month to ensure proper tightness. If wheel
wobbles or is loose, release lock nut and tighten axle
bolt slightly. Test for proper tightness by learning chair
to one side and spin adjusted wheel.
- Wipe chrome parts with a clean,

GENERAL CARE

soft cloth at least once a week. All metal parts can be
cleaned with auto wax or similar poducts. If exposed
to moisture, dry immediately. Do not use an abrasive
cleanser that will scratch the finish.
- Open wheelchair by tilting to one side
TO OPEN CHAIR
and pushing down on seat rail until fully opened.
TO CLOSE/FOLD CHAIR
position. Grab seat with both hands at front and back
edge and lift. Or, tilt chair to one side and lift up on seat
rail.
- Remove arms by depressing spring
REMOVABLE ARMS
button and lifting arms out of front and rear sockets.
EXAMINE THE FOLLOWING ANNUALLY.
• Back and seat for damage
• Bent frame or cross braces
• Loose, missing, or damaged nuts, bolts, and screws
• Hand grips and arm pads
Replace, repair, or tighten as necessary
- Lift foot plate on
- First fold foot plates to vertical
WARNING
Do not attempt to adjust or operate wheelchair
without reading carefully all instructions in this manual.
This wheelchair has not been approved as a seat that
can be used within vehicles of any kind. Always transfer
wheelchair user to a vehicle manufacturers approved
seat and use safety restraints available.
Do not operate this wheelchair on roadways, streets or
any surfaces with vehicular traffic.
Do not attempt to operate on inclines 10% or greater
without proper assistance.
Be sure to completely engage wheel locks when
getting in and out of wheelchair or when in elevator or
wheelchair lift.
Wheelchair should be on a smooth, stable and level area
with wheel locks engaged before transferring user in or
out of wheelchair.
Do not adjust foot rests any lower than 2-1/2" from floor.
When getting in or out of wheelchair, do not stand on or
apply weight to foot rests.
Before reaching or leaning forward, rotate casters to
front of the wheelchair engage wheel locks to help
prevent wheelchair from tipping over.
Do not lean over or apply weight to the top of
wheelchair back. This can cause wheelchair to tip over.
When trying to extend arms over back, only reach as
far as your arm can extend without having to alter your
seating position.
DO NOT stand on wheelchair.
DO NOT use wheel locks to slow your descent down
an incline.
Abruptly changing directions while going down an incline
could cause instability or possible tipping over.