Wheel Locks - Drive Medical P682A/STD30DDAHTREV1 Mode D'emploi

Item #STD30DDA Shown
For use with all
Sentra Heavy Duty Extra Wide Wheelchairs
WEIGHT CAPACITY: 700 LBS
CAUTION:
Stability - Wheelchair is designed to be safe and stable as long as
center of gravity is maintained while going about normal activities.
Care must be taken while performing activities that shift your
center of gravity in the chair. Never reach so far that require you
to shift in the seat or bend over out of the chair. When you have to
reach for objects that require you to lean, be certain front casters
are pointing in a forward position that extends the wheel base and
will stabilize the chair.
Ramps - Be sure of your own capabilities, limitations and strength
before attempting to go up a ramp. Correct techniques on ramp
negotiation should be shown to you by a qualified professional.
Assistance is recommended when going up or down inclines greater
than 10 . If you must stop on an incline, avoid sudden, abrupt
o
movement when you resume movement. Because of backward
angle of the chair, sudden abrupt movement could cause instability.
Attempting to use the wheel lock brakes could result in accidental
locking, tipping to one side, or cause a sudden stop. Avoid changing
direction when going down an incline, as this could result in
instability of tipping over.
Please read this manual carefully to insure safe usage and
understanding of maintenance instructions.
Congratulations on your purchase of a Drive wheelchair.
Drive wheelchairs are a product of quality engineering
and are manufactured to meet our own highly rigid
specifications and will surpass all your expectations.
Use and Safety
- Engage both wheel locks before getting

WHEEL LOCKS

in or out of chair, leaning forward in chair, or while in an
elevator or wheelchair lift. Proper adjustment of wheel
lock is at least 1/8" when locked. Locks are engaged by
pushing handle completely forward. Adjustments to locks
are made by loosening or tightening nut on the carriage
bolt. Embed lock shoe at least 1/8" by sliding clamp toward
rear wheel while handle is engaged in locked position.
Tighten nut and bolt to secure in position. Test for correct
locking action before actual use. Every 3 months, check
wheel lock to ensure it is tight on frame. If loose, follow
above adjustment instructions.
- Solid rubber tires need minimal maintenance, but
TIRES
should be cleaned occasionally with a damp cloth. Replace
if tires become severely worn or cracking appears.
REMOVAL OF SWING-AWAY FOOT RESTS/LEG RESTS
Release lock by pushing on the front rigging lever. Swing-
away foot rest /leg rest out and sideways. Lift to remove.
ADJUSTING LENGTH OF FOOTREST/LEG REST
adjusting length of foot rests or leg rests, user should be
sitting in wheelchair with feet on the foot plates. Loosen
bolt on the clamp around support assembly. Raise or
lower foot plate to desired position that will provide
maximum support of thighs. Front rigging should not be
-
- When