Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
•
In order to achieve good transmission quality and noise canceling, as well as best possible comfort,
the headband should be adjusted to properly fit your band. You can adjust the headband using the
snap-in locking mechanism.
•
Connect the headphones via supplied audio cable to the sound source. If necessary, use the 6.3mm
jack adapter or the 3.5mm double jack adapter for the in-flight entertainment in an airplane.
•
Adjust the volume at the headphones.
Active Noise Cancelling Function:
•
To switch on the active noise canceling function and to attenuate ambient noise set the ON/OFF
switch to ON. The POWER indicator lights up.
Note: After you turn on the power of the headphones, you may hear a slight hiss. This is operating
sound of the noise canceling function, not a malfunction
•
When the batteries are running low, the Noise Cancelling LED indicator will become dim.
•
When the batteries are going flat, the active noise canceling is switched off. However, the audio signal
continues to be transmitted.
•
After operation, switch off the headphone to extend battery life.
BT on/off and pairing
•
To power ON your headphones: Press and hold the Multifunction Button (MFB) for about 4 seconds
until the BT LED indicator light starts flashing green/red rapidly with an ascending sound.
•
To power OFF your headphones: Press and hold the MFB for about 5 - 6 seconds until the BT LED indi-
cator light turns solid red with a descending sound
The headphone works with BT-enabled mobile phones. Prior to using and pairing your headphone for
the first time, please check to make sure that your mobile phone is BT-enabled.
The pairing instructions for typical BT-enabled mobile phones are explained in "Pairing Your Head-
phone." The headphone pairing procedure may vary depending on the settings of your mobile phone.
Please contact the manufacturer of your mobile phone or its agent for further information.
•
Press and hold the MFB for about 4 seconds until the BT LED indicator flashes alternately between
green and red. Now the BNC40 will enter into pairing mode.
•
Enable searching of nearby BT devices using the BT menu on your device.
•
Once the "BNC-10" is found, you can now connect and pair. If your device prompts you for a password,
please use "0000" - For more details, please refer to your device's owner manual.
•
When pairing is successful, the BT LED indicator will flash green every 4 seconds. If pairing is unsuc-
cessful, please turn off the BNC40 headphones and repeat the pairing steps.
•
After initial pairing is established, the headphones will automatically reconnect to the last paired de-
vice upon turning ON
Controls:
Answer / End a call
Ignore incoming call
10
Press MFB once
Hold MFB for 3 seconds
Publicité
Table des Matières
