Lubrication - Vulcan GH Serie Manuel D'installation Et D'utilisation

Heat Tint
Straw-colored or slightly darkened areas may appear on stainless steel in and around ovens and
ranges where temperatures reach 500°F (260°C) or more. This "heat tint" is caused by a slight oxidation
of the stainless steel and is not harmful.
To control or minimize this condition, never use more heat than is absolutely necessary.
Heat tint can be removed by scouring vigorously with stainless steel wool and a paste made of scouring
powder. Remember to rub in the direction of the polish lines.
Commercial heat tint remover products may also be used.
Precautions
When scraping off heavy deposits of grease or oil from stainless steel equipment, never use ordinary
steel scrapers and knives. Particles of ordinary steel may become embedded in, or lodge on, the
surface of the stainless steel. These will rust, causing unsightly stains and possible contamination of
food. Where it is necessary to scrape, use stainless steel, wood, plastic or rubber tools.
MAINTENANCE
WARNING: (CONVECTION OVEN MODELS ONLY) DISCONNECT THE ELECTRICAL
POWER TO THE MACHINE AND FOLLOW LOCKOUT/TAGOUT PROCEDURES.

LUBRICATION

Motors in Vulcan convection ovens are permanently lubricated and require no additional maintenance.
If the gas valve is hard to turn or leaking, contact your local service agency.
FLUE
Annually check the flue when it is cool to be sure it is free of obstructions.
SERVICE AND PARTS INFORMATION
To obtain service and parts information concerning this model, contact the Vulcan-Hart Service
Agency in your area (refer to our website, www.vulcanhart.com for a complete listing of Authorized
Service and Parts depots).
When calling for service, the following information must be available: model number, serial number,
manufacture date (MD) and voltage.
– 23 –