Maintenance - oneConcept 10006736 Mode D'emploi

2. Putting in washing agent: for the washing agent, please refer to washing agent for
woolen fabric. In order not to damage the fabric of pure animal hairs, please use neutral
washing agent without ferment.
3. Putting in washings: woolen washings should be put into the net and washed on their
reverse sides.
4. Washing: wash them flow for 2min then introduce water to rinse them for 2min, take
them out, flatten them and keep them in good shape. Do not dry them in the sun but
dry them in cloudy days.
Method for woollen blanket
Washing pure woollen blankets and electric blankets are absolutely forbidden.
1. Fold the blanket four times in upright direction, then roll it up and put it into the net bag.
2. Put the blanket into the washing tub and press it lightly with hand so as to make it full
of water and sink down to the water bottom.
3. According to the weight and volume of the blanket,adjust the water level.
4. Select washing time and start washing.
• Sometimes the washings make the water in the tube spill out. It is better to cover the
tub with the lid.
1. Please pull the plug out of the socket (do not touch the socket when your hands are wet)
and put it at the correct position.
2. After discharging the water in the tub,please move the switch from discharge to standard.
3. Clean the de-hair device:
a) Take out the de-hair set, dismantle it with a finger pressing the inside bottom.
b) Put the de-hair set in water to clwan.
c) After cleaning, restore the de-hair device, insert it into the slat wnder the water level
side board. A click should be heard.
4. Pick up the water introducing tube and hang the discharging tube.
5. Clean the housing of the machine, wipe it thoroughly, and wipe out the dirt with
chemicals, such as alcohol, eradicator, acetone, gas, etc. When it is very dirty, please
use neutralliquid soap to clean.
6. Close the lid, placed the machine at the ventilation in the room.
• Water is not allowed to enter the inner part of the machine directly. Otherwise, the electric
motor will be conducted by electricity. Danger of electric shock!
• If the supply cord is damaged, it must be replaced by the manufacturer, their service
16

Maintenance