Starway modena Manuel De L'utilisateur page 41

Masquer les pouces Voir aussi pour modena:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Make sure that the device is not exposed to extreme heat or dust.
Make sure that the available voltage is not higher than stated on the rear panel.
Make sure that the power cord is never crimped or damaged. Check the device and the
power cord from time to time.
Make sure that the core diameter of extension cords and power cords is sufficient for the
required power consumption of the device.
Always hold the device by the transport handles.
Never place any material over the LEDs or lens.
Never look directly into the light source.
Never leave any cables lying around.
Never use the device during thunderstorms, unplug the device immediately.
Never leave various parts of the packaging (plastic bags, polystyrene foam, nails, etc within
children's reach, as they potential sources of danger.
Do not insert objects into air vents.
Do not open the device and do not modify the device.
Do not connect this device to a dimmer pack.
Do not switch the device on and off in short intervals, as this will reduce the device's life.
Do not touch the device's housing bare-handed during its operation (housing becomes very
hot). Allow the device to cool for at least 5 minutes before handling.
If the lens or LEDs are obviously damaged, they need to be replaced to prevent their func-
tions from being impaired, due to cracks or deep scratches.
If the external cable is damaged, it has to be replaced by a qualified technician.
If device was dropped or struck, disconnect mains power supply immediately. Have a quali-
fied engineer inspect for safety before operating.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation),
do not switch it on immediately. The arising condensation water might damage your device.
Leave the device switched off until it has reached room temperature.
If your device fails to work properly, discontinue the use immediately. Pack the unit securely
(preferably in the original packing material), and return it to your dealer for service.
For adult use only. The device must be installed beyond the reach of children. Never leave
the unit running unattended.
Never attempt to bypass the thermostatic switch or fuses.
For replacement use fuses of same type and rating only.
This device is heavy. When handling, use a two-person lift to prevent injury.
The user is responsible for correct positioning and operating of the device. The manufactur-
er will not accept liability for damages caused by the misuse or incorrect installation of this
device.
This device falls under protection class I. Therefore it is essential to connect the yellow/
green conductor to earth.
Repairs, servicing and electric connection must be carried out by a qualified technician.
This device is heavy. When handling, use a two-person lift to prevent injury.
Please follow the European and national guidelines concerning rigging, trussing and
Rigging
all other safety issues.
Page 41

Publicité

Chapitres

Table des Matières
loading

Table des Matières