Vortice SCNR5 Notice De Pose Et D'entretien page 9

3) Insert (A) (through the two holes to be drilled) the leads that have to be
connected to the unit and power supply, making sure the length allows their
connection to the terminal board (Figures 1 or 1a).
4) Fix (A) the intermediate wiring support (B) on the base using the screws
provided (Figures 1 or 1a).
Connect the terminal board of the regulator in accordance with the
instructions provided in the diagram (Figures 2 or 2a). Tighten the cables
with the screws and cable clamps provided.
5) Fix the intermediate wiring support (B) to the cover (C) using the screws
provided (Figures 3 or 3a)
Operation (Figure 4)
1) Press key (D) (the pilot light turns on) to start the fan.
2) Turn the knob (E) to select the desired speed.
Operation (Figure 4a)
1) Press key (D) (the pilot light turns on) to start the fan.
2) Press key (F) to turn the fan light on.
3) Turn the knob (E) to select the desired speed.
9