Getting Started/Operation; Setting The Frequency - DNT MusicFly SD Mode D'emploi

Getting started
Place the MusicFly Select into the 12V cigarette lighter socket
power. Adjust the device, that it can be operated comfortably.
The display turns on instantly. The equipment is ready for use.
The MusicFly Select checks whether a device is attached to
the USB port or a SD card is in the card slot and goes into the
pause mode
Turn on from Standby-Mode
Press and hold the MEM SD-USB button for 2 seconds to turn
the unit on. The previous display settings appear. The MusicFly
Select checks whether a device is attached to the USB port or a
SD card is in the card slot. Start the playback with the
Turn off
Hold down the MEM SD-USB button until the device is off.
Standby-Mode
If no audio device is connected to the USB port or an audio
input is not connected or pause is pressed, the device turns
off the transmission after about 1 minute. In the radio a noise is
heard. If a audio signal is connected within the next 60minutes
the MusicFly SD turns on automatically. Otherwise it is neces-
sary to press the MEM SD-USB button to turn it on.

Setting the frequency

Press MENU button.
Select the frequency with
Press MENU button again.
Playback
Description & Functions
.
Press button to start playback or pause.
When the music is playing, press briefly
buttons, to move to the next or previous title.
Press and hold the
seconds to move to the next or previous directory.
Press MENU button again.
/
buttons.
/
- 19 -
button.
buttons for about 2
/