Environmental Protection - F.F. Group CRH/2-20-BL 20V PLUS Notice Originale

CRH/2-20-BL 20V PLUS
4. Changing the
chiseling posi-
tion
The chisel can be
locked in 12 posi-
tions. In this man-
ner, the optimum
working position
can be set for
each application.
Insert the chisel
into the tool
holder. Adjust the
chiseling position
to your desired
angle, then switch
to chisel mode to
apply.
SWITCHING ON AND OFF
To start the machine, press the On/Off switch (4).
ƒ
When starting the machine for the first time, a
starting delay is possible, as the electronic system
of the power tool has to configure itself first. To
save energy, only switch the power tool on when
using it.
To switch off the machine, release the On/Off
ƒ
switch (4).
SETTING THE SPEED/IMPACT RATE
The speed/impact rate of the switched on power
tool can be variably adjusted, depending on how far
the On/Off switch (4) is pressed.
Light pressure on the On/Off switch (4) results in
low speed/impact rate. Further pressure on the
switch increases the speed/impact rate.
OVERLOAD CLUTCH
If the tool insert becomes caught or jammed,
f
the drive to the drill spindle is interrupted. Be-
cause of the forces that occur, always hold the
power tool firmly with both hands and provide
for a secure stance.
If the power tool jams, switch the machine off
f
and loosen the tool insert. When switching the
machine on with the drilling tool jammed, high
reaction torques can occur.
RECOMMENDATIONS FOR OPTIMAL HANDLING
OF THE BATTERY
Protect the battery against moisture and water. Store
the battery only within a temperature range between
10°C and 30°C. As an example, do not leave the battery
in the car in summer.
Occasionally clean the venting slots of the battery us-
ing a soft, clean and dry brush.
A significantly reduced working period after charging
indicates that the battery is used and must be replaced.
Observe the notes for disposal.
MAINTENANCE AND SERVICE
MAINTENANCE AND CLEANING
Before any work on the machine itself (e.g.
f f
maintenance, tool change, etc.) as well as during
transport and storage, remove the battery from
the power tool. There is danger of injury when unin-
tentionally actuating the On/Off switch.
For safe and proper working, always keep the
f f
machine and ventilation slots clean.
A damaged dust protection cap should be
f f
changed immediately. We recommend having
this carried out by an after-sales service.
Clean the tool holder (1) each time after using.
ƒ

ENVIRONMENTAL PROTECTION

Recycle raw materials instead of disposing as
waste. Machine, accessories and packaging
should be sorted for environment - friendly
recycling. The plastic components are labeled
for categorized recycling.
GUARANTEE
This product is warranted in accordance with the
legal/country specific regulations, effective from
the date of purchase by the first user. Damage
attributable to normal wear and tear, overload or
improper handling will be excluded from the guar-
antee. In case of a claim, please send the machine,
completely assembled, to your dealer or the ser-
vice Centre for electric power tools.
English | 11
www.ffgroup-tools.com