Behringer CRAVE Guide Rapide page 62

62
CRAVE
CRAVE Sequencer operation
Step 4: Sequencer operation
(EN)
CREATING A PATTERN IN STEP MODE
1. Press SHIFT and STEP> to select the Sequencer's STEP
mode. The flashing LOCATION LED will turn from green
(Keyboard mode) to yellow (Step mode).
2. Initialise the current pattern by pressing SHIFT, RESET, and
PATTERN at the same time. This will delete any previous
steps of the current pattern. (If you want to use the current
pattern instead, then do not initialise it.)
3. Press PAGE to move to a desired page of your pattern.
Then press SET END and a STEP switch to choose the length
of the pattern. For example, if you are on page 1 and press
SET END + 8, then the pattern length is 8 steps. If you
press PAGE and reach page 4, and press SET END + 8, then
the pattern will be 32 steps long (4 pages of 8 steps each).
4. When the desired SET END is selected, all the STEP switch
LEDs up to that step will be on solid red.
5. Press SHIFT and any one of the STEP switches at the same
time. It will begin to flash, indicating it is the current
step about to be edited. You can now add a note, or a
rest, or any of the other functions described above in the
Keyboard mode, such as Ratchet, Glide, Accent, change
gate length and so on.
6. Press SHIFT and the current STEP switch to finish editing
that step. It will stop flashing.
7. Repeat procedure steps 5 and 6 above, until all your
required steps are good.
8. Press PLAY/STOP to play the pattern.
9. While playing, you can add temporary adjustments as
shown in the "LIVE PERFORMANCE" procedure above.
SAVING A PATTERN IN STEP MODE
Save the pattern using the "SAVING A PATTERN" procedure shown
above for the KEYBOARD mode.
Caution: Do not turn off the unit, or create a new pattern, or the
current unsaved pattern will be lost.