Grounding Instructions - Johnson Horizon 7.8 AT Guide Du Propriétaire

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

GROUNDING INSTRUCTIONS

This product must be grounded. If a treadmill should malfunction
or breakdown, grounding provides a path of least resistance
for electrical current to reduce the risk of electrical shock. This
product is equipped with a cord having an equipment-grounding
conductor and a grounding plug. The plug must be plugged into
an appropriate outlet that is properly installed and grounded in
accordance with local codes and ordinances.
DANGER!
Improper connection of the equipment-grounding conductor can
result in a risk of electric shock. Check with a qualified electrician
or service provider if you are in doubt as to whether the product
is properly grounded. Do not modify the plug provided with the
product. If it will not fit the outlet, have a proper outlet installed by
a qualified electrician.
This product is for use on a nominal local voltage circuit and has a
grounding plug. No adapter should be used with this product.
This product must be used on a dedicated circuit. To determine
if you are on a dedicated circuit, shut off the power to that circuit
and observe if any other devices lose power. If so, move devices to
a different circuit. Note: There are usually multiple outlets on one
circuit.
WARNING!
Connect this exercise product to a properly grounded outlet only.
Never operate product with a damaged cord or plug even if it
is working properly. Never operate any product if it appears
damaged, or has been immersed in water. Contact Customer Tech
Support for replacement or repair.
4
LOCATION OF THE TREADMILL
Place the treadmill on a level and stable surface. There should
be one foot of clearance in front of the treadmill for the
power cord. Please leave a clear zone behind the treadmill
that is at least the width of the treadmill and at least 79" (2
meters) long. This zone must be clear of any obstruction and
provide the user a clear exit path from the machine. In case
of an emergency, place both hands on the side arm rests to
hold yourself up and place your feet onto the side rails.
For ease of access, there should be an accessible space
preferentially on both sides of the treadmill equal to 2 ft (0.6
meters) to allow a user access to the treadmill from either side.
Do not place the treadmill in any area that will block any vent or air
openings. The treadmill should not be located in a garage, covered
patio, near water or outdoors.
WARNING!
Our treadmills are heavy; use care and additional help if necessary
when moving. Do not attempt to move or transport treadmill
unless it is in the upright, folded position with the lock latch
secured. Failure to follow these instructions could result in injury.
FOLDING TREADMILLS
Some treadmills have a deck that can fold for storage and
transport. To fold, firmly grasp the back end of the treadmill.
Carefully lift the end of the treadmill deck into the upright position
until the lock latch engages and securely locks the deck into
position. Make sure the deck is securely latched before letting go.
UNFOLDING
Firmly grasp the back end of the treadmill. If your treadmill has a
FOOT LOCK LATCH (A), to unfold, gently press down on the foot
lock latch with your foot until the lock latch disengages. If your
treadmill has a DECK LOCK LATCH (B), pull the deck lock latch
to release the deck. Carefully lower the deck to the ground.
30
(1
)
cm
ft
60
tRAINING
60
cm
cm
(2
)
AREA
(2
)
ft
ft
2
(79")
m
fREE
AREA
B
A

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Htm1319-01

Table des Matières