Johnson Horizon 7.8 AT Guide Du Propriétaire page 12

MAINTENANCE SCHEDULE
LUBRICATING THE RUNNING BELT
EVERY 3 MONTHS OR 300 MILES
It is necessary to lubricate your treadmill running deck every three months
or 300 miles to maintain optimal performance. Once the treadmill records
300 miles it will display the message "LUBE" or "LUBE BELT." The treadmill
will not operate while the message is showing. Your treadmill came with a
bottle of 100% silicone lubricant, which can be used for two applications.
Go to this website to purchase additional Silicone
Lubricant: www.johnsonfit.com/lubricant
Tools Needed:
• Blue-handled T-wrench or Allen wrench
• 100% silicone oil
PROCEDURE:
1. Turn off the treadmill with the on/off switch and unplug the power cord at the wall outlet.
2. Using the T-wrench or Allen wrench, loosen the rear roller bolts
3. Lift the belt as far as you can and squirt the silicone oil in a zigzag pattern across the entire running deck surface.
4. After you have applied lubricant, plug in the power cord, and insert the safety key. Reset the Lube Belt message by
5. Stay off of the machine and press START. Allow the belt to run at 3 mph for 3 minutes to begin
6. Once the belt is centered and tensioned, stop the belt. Wipe any excess oil from the sides with a damp cloth.
Press any key to suspend the lubrication warning message until after your next workout. Note: Some older
models may require you to hold stop for 5 seconds to suspend message for 5 miles of use.
If your treadmill has air shocks under the deck for lift assistance, lubricate the silver air shock
tube with Teflon-based spray found at your local hardware or bike store.
Visit the Customer Support section of our website to view "how-to" maintenance videos. Please contact
Customer Tech Support with questions about applying lubricant to your treadmill.
12
10-15 counter-clockwise turns. This should give the belt enough slack for you to lift it.
Use 1/2 bottle of silicone lubricant. Do not apply the silicone oil on top of the running belt. Lay the running
belt down and then tighten both rear roller bolts clockwise the same number of turns loosened.
first pressing and holding the SPEED UP button, then STOP button and hold BOTH buttons for 5-7 seconds.
spreading the silicone. Then walk on the machine at a comfortable speed for 3 minutes to complete
spreading the silicone and to check the running belt for proper tension and alignment.
RUNNING
BELT
RUNNING
DECK