Special Notes - Haider BIOSWING 350 Mode D'emploi

VarioBackMatic (backrest tilt/pressure)
10
The VarioBackMatic responds to the backrest pressure and automatically syn-
chronizes seat and backrest for a physically beneficial motion sequence. Try
to adjust the backrest pressure level so that you never feel to have to apply
too much force to lean back. In this way, you motivate yourself to change your
sitting position frequently; thus, promoting positive lumbar effects.
Adjustment of Backrest Tilt: Individually or with Permanent Contact
While sitting, pull the operating element
your movements. As soon as you release the lever, the backrest is fixed.
You can activate the permanent-contact mechanism by pulling the operating
element upward and subsequently pushing it backward.
10a
Individually Adapted Back Pressure
While sitting, pull the operating element
ward so that you can adjust the back of the seat`s tilt. Turn the hand wheel
, which is located at the right under the seat surface, clockwise to in-
10b
crease the back pressure. Meanwhile, turning the hand wheel counterclock-
wise decreases the back pressure.
10a
upward. The backrest follows
10a
upward and then push back-
10a
10b
english | 30

Special Notes

Use the office swivel chair only – as intended – to sit on it. Never stand on
the chair.
Gas Spring
In order to adjust the height, only specialist staff is allowed to make changes
and perform work in the area of the gas spring. Do not heat or open the
pneumatic spring with force.
Castors
For your safety, the office swivel chair is equipped in series with self-braking
castors in order to impede the movement of an empty chair.
Pay attention to the correct choice of castors according to the floor cover-
ing.
If the chair is used on a soft floor (e.g. carpet), it should be equipped with
hard castors. Hard castors are single-colored.
If the chair is used on a hard floor (e.g. parquet, linoleum, tiles), it should be
equipped with soft castors. Soft castors are two-colored, which means that
the tread has a different color.
Maintenance and Care
If the office swivel chair is used as intended, it is maintenance-free. Clean
paint/plastic and metal surfaces with a soft hand brush or cloth with mild
detergent, soap, or grease-dissolving liquid. According to how much the
chair is used, a regular cleaning of the upholstery cover is recommended.
The fabric/micro-fiber cover can be made dirt free by vacuum-cleaning it or
with the help of standard dry foam. Leather coverings can be kept smooth
for years by using standard leather-care products (solar radiation). Stains
should be treated immediately. Check the effect of cleaning products first
at a place that is not visible. Otherwise, select cleaning-agents can cause
color discrepancies when compared to the untreated areas.
english | 31