Safety Information - Nakayama SP7500 Traduction De La Notice Originale

Safety Information

The equipment complies with the safety
regulations required for electrical equip-
ment.
Read through the instructions for use before
starting up the equipment.
Improper use can lead to personal injury and
property damage. Persons, who are not famil-
iar with the instructions, may not operate the
equipment. Keep the instructions for use in safe
custody.
Children and youths are not permitted to operate
the equipment.
This Pump
water that is soiled and which contains foreign
matter from garden ponds, cel-
The manufacture assumes no liability whatsoever
for improper use or if the machine has been tam-
pered with.
Give equal attention to the safety instructions,
assembly and operating instructions as well as
prevailing accident preventions regulations.
Don't turn the device on if there are people in the
water to pump.
mable or dangerous liquids or salt water.
The water temperature must not exceed 35ºC.
Safety Information
The mains voltage must correspond to the infor-
mation on the machine's type plate.
The equipment should only be operated using
one residual current circuit breaker, and for use
in swimming pools, garden ponds, or fountains
according to VDE 0100, only using one residual
current circuit breaker with nominal residual cur-
rent ≤ 30 mA.
Ask an electrician.
6
suited to emptying
cellars.
Have an expert check the grounding and voltage
zeroing.
Protect the electrical plug and socket connection
from moisture and place it an area that is safe
Protect the equipment from frost and dry run-
ning.
Before start-up, check the equipment and cables
for any damages.
Keep children away from the connected equip-
ment.
Unplug the power plug before performing any
work on the equipment.
Only pull the cable from the receptacle with the
plug.
Protect the plug and cable from heat, oil, and
sharp edges.
Do not use the pressure line or the power cable to
fasten or transport the equipment.
Only use accessories recommended by the manu-
facturer.
Installation
Stationary
Hang the pump on the carrying handle or on
the bottom of the shaft, but never hang it by the
cable or pressure hose.
The bottom of the shaft must always be free of
sludge or other impurities and have dimensions
move freely.
Make sure that the pressure line is properly
attached.