Snooze Function; Sleep Operation - Denver CR-718 Mode D'emploi

Action (during data adjustment):
- Press << / Tune - (8) button to adjust data backward.
- Press >> / Tune + (9) button to adjust data forward.
- Keep depressed << or >> button for 2 seconds to enable auto
forward.
- Use ALARM 1 / ALARM 2 set button to confirm each setting.
ALARM
Beep alarm or radio alarm will ring for 30 minutes if no key is pressed,
then it will stop automatically and wait for same alarm time on next
day.
Enable / disable the Alarm
Press and hold the "ALARM 1" (6) / "ALARM 2" (7) button to enable or
disable the alarm. Once the alarm is activated, the bell symbol will be
appeared on the display.

SNOOZE FUNCTION

When Alarm rings, press Snooze button (1) to suspend the alarm & to
activate the snooze function, Beep or Radio alarm will stop. 9 minutes
later the alarm will ring again. Press SNOOZE button (1) again, alarm
will be suspended again, another 9 minutes later the alarm will ring
again and so on until the next alarm rings.
Note: The interval time of the Snooze function is 9 minutes.
- If you want to disable the SNOOZE function and stop alarm
completely, press Radio ON/OFF button (13). If you don't press any
button, the alarm will ring during 30 minutes & stop automatically.
- Icon of ALARM 1 and ALARM 2 will blink as long as Snooze
function is still operating. Once Snooze is turned off icon of ALARM
1 / ALARM 2 stop blinking and lights on the display.

SLEEP OPERATION

When you listen to the radio, press the SNOOZE/SLEEP/DIMMER
(1) button to enter into the sleep mode. You can adjust the sleep timer
from 90 minutes to 15 minutes by pressing repeatedly the SNOOZE/
SLEEP/DIMMER button (1). When sleep timer is selected, the unit will
automatically turn off once time is up.
.