FLAEM AirMate Mode D'emploi page 5

2. Pour the medication prescribed by the doctor into the lower part (C1.1). Insert the
upper part (C1.2) into the lower part (C1.1), close the nebuliser by turning the upper
part (C1.2) clockwise. Insert the Drugsaver (C1.3) as show in the "Assembly diagram"
in point C1.
3. Connect accessories as indicated in the "Connection diagram" on the cover.
4. Sit comfortably holding the nebuliser in your hand,
place the mouthpiece onto your mouth or alternative-
ly use the nose piece or mask. Should you opt for the
mask accessory, place it on your face as shown in the
picture (with or without using the elasticated strap).
5. Start the device by means of switch (A1) and breathe
deeply in and out. After inhaling, we recommend
holding your breath for an instant to allow the inhaled
drops of aerosol to deposit. Then exhale slowly.
6. Upon completing application, switch off the device
and unplug it.
ATTENTION: If after the therapy session an evident deposit of moisture forms within
the pipe (B), detach the pipe from the nebuliser and dry it with the very ventilation
from the compressor; this operation prevents possible blooms of mould inside the
pipe.
SOFTTOUCH FACE MASKS
Soft
biocompatible
material
Dispersion
Limiting Vent
During the inspiratory phase,
the tab, acting as a Dispersion
Limiting Device, bends inwards
towards the mask.
CLEANING SANITISATION DISINFECTION
Switch off the device before any cleaning procedure and unplug the power cable from the
socket.
DEVICE AND TUBING EXTERIOR
Use only a damp cloth with antibacterial soap (non-abrasive and with no solvents of
any sort).
ACCESSORIES
Open the nebuliser by turning the upper part (C1.2 ) anticlockwise, remove the upper
part (C1.2-C1.3) as shown in the "Assembly diagram" in point C1.
Then proceed according to the following instructions.
SANITISATION
Before and after each use, sanitise the nebuliser cup and the accessories, choosing one
of the methods described below.
method A: Sanitise accessories C1.1-C1.2-C1.3-C2-C3 under potable hot water
(approximately 40°C) with a gentle, non abrasive dish detergent.
method B: Sanitise accessories C1.1-C1.2-C1.3-C2-C3 in the dishwasher with a hot
SoftTouch masks have an outer edge made of soft
biocompatible material that ensures excellent
adherence to the face, and is also equipped with
an innovative Dispersion Limiting Device. These
distinctive elements that distinguish it allow great-
er sedimentation of medication in the patient and
also limit dispersion.
During the expiratory phase,
the tab, acting as a Dispersion
Limiting Device, bends out-
wards from the mask.
3