Radio Connector - KEY 900SC-C Manuel D'emploi

PROGRAMMING THE TRAVEL
Plug in and turn on the reduction gear after making sure adequate safety devices are installed (circuit
GB
breaker).
1st phase: total reset.
Hold down the program button (P1), turn on the control unit and release the button after the light blinks 5
times.
2nd phase: programming the travel.
Make sure the carriage is hooked to the chain or belt and that it is about mid opening travel.
Lift dip switch 4 (MEMO FUNCTION). The control unit will emit an intermittent tick and the courtesy light will
blink.
Press the PP button (red button). The motor will move the carriage and the door will lower towards closing.
It will automatically stop when it reaches the door stop.
Press the P1 button (black) to confirm travel stop.
Press the PP button (red). The door will open and the user can set the end of opening travel by pressing the
PP button (red). (warning - there may be an inertia of about 10mm) .
Confirm the maximum opening position by pressing the P1 button (black)
Return dip switch 4 to its original position (off)
Travel has now been saved.
Run three complete open/close cycles so that the system automatically sets force.
Closing force can be adjusted using Trimmer T1.
Pause time can be set using trimmer T2.

RADIO CONNECTOR

The CT-24S unit is compatible with the following Keyautomation receivers of the MEMO snap-in series:
900RXI-41 / 900RXI-41R / 900RXI-42 / 900RXI-42R
19