Vegetable Press - Klarstein 10031667 Mode D'emploi

Marking
23

Vegetable Press

Assembly:
1. Insert the worm shaft into the cutter housing, the plastic end first. Place the cone
in the cutter housing. Place the former on the cutter housing and screw the ring
on the cutter housing.
2. Attach the cutter housing to the motor unit.
3. Place the tray on the upright part of the cutter housing.
4. Now the appliance is ready for making tomato mush.
Tips:
Screw ring D is marking 0,1,2,3 (see the picture). When you disassemble the accesso-
ry, you should put the screw ring D to marking 0 first. Then you can start extracting
your vegetables.
If you want to extract the vegetables with more cellulose, you should rotate screw
ring D to marking 1, rotate screw ring D to marking 2 for little cellulose, and rotate
screw ring D to marking 3 for few cellulose.