Axis Q60 Serie Guide D'installation page 10

Page 10
Install AXIS T8124 High PoE Midspan 1-port
Axis T8124 High PoE Midspan enables Axis network video products with high power consumption
to receive data and power over the same Ethernet cable. Follow these instructions to connect
AXIS T8124.
Note:
Axis can only guarantee full functionality with AXIS T8124, no other High PoE devices are
supported.
1. Connect AXIS T8124 (Data in) to the network switch using a standard network cable.
2. Connect AXIS T8124 (Data and Power Out) to the network camera, using the network cable that
has been connected to the camera.
3. Connect AXIS T8124 to an AC outlet (100-240 VAC), using the supplied power cable.
connectivity
connectivity
For information on the LEDs on the midspan, see
Note:
Always use a shielded network cable (STP) intended for outdoor use between the camera
and the end point and ensure that the end point is properly grounded. Installations of Axis
cameras using a shielded network cable (STP) and a properly grounded end point have been
tested to comply with industry immunity standards' levels such as surge protection. Any
other installation method will void the warranty and leave the unit at a risk.
AXIS T8124
Port
indicator
AC Input
indicator
Network camera
AXIS Q6032-E/Q6034-E/Q6035-E Installation Guide
Data &
Power out Data in
Ethernet
Assign an IP address,
on page 11.