AEG 10714 Mode D'emploi page 17

Fire hazard
• Verify the on-board vol-
tage matches the input
voltage specified on the
device (12 V DC) to prevent
damage to the device.
• The coolbag is not sui-
table for continuous use.
Otherwise overheating and
permanent damage may
result.
Do not cover the device
•
whilst charging, as it may
be damaged from extreme
heating.
Immediately stop using the
•
device if you notice smoke
or an unusual odour.
Risk of electrical
shock!
• Do no expose the device
to rain or wet conditions.
Avoid pouring or dripping
water or other liquids over
it. If water penetrates elec-
trical devices, the risk of
electric shock increases.
• Please verify there is no
moisture on plugs and
cables. Never connect the
device to the on-board
power system with wet
hands.
Always unplug the cable
•
from the 12 V car outlet by
the plug. The cable may
otherwise be damaged.
• Do not use device if
damaged. Damage to the
device or the charging
cable increases the risk of
electrical shock.
• Do not attempt to di-
sassemble or repair the
device. Immediately have
the device repaired or re-
placed by a speciality shop
if defective.
• Never use the cable to
carry or pull the device.
• Never operate the device
if it has been dropped
English 17