Publicité
Assemble Clamps
D (2)
G (2)
H (2)
J (2)
T (2)
U (2)
1. Place two mounting boards (D) on
stand, slots on top and toward the
outside of stand. See Figure 15.
2. Place upper clamp brackets (G) into
slots in boards. See Figure 15.
3. Place washer (T) over hole on upper
clamp bracket and, while holding
lower clamp bracket (H) under
frame, thread knob (J) into lower
clamp bracket. See Figure 15.
4. Using an adjustable wrench, add
nylock nut (U) to each knob. Nut
should only be threaded on
enough to be flush with end of
stud. See Figure 16.
14
Figure 15
Figure 16
Publicité
Chapitres
