Publicité
Les langues disponibles
Les langues disponibles
WARNING:
This heater is not equipped with a device to control the room temperature. Do not
use this heater in small rooms when they are occupied by persons not capable of
leaving the room on their own, unless constant supervision is provided.
Preparation
1.
Unpack the carton. Take out the accessories pack from the carton of the
heater body. Make sure the accessories listed in the above Accessories Check
List are included. If anything missing, ask the retailer immediately to provide it
to you.
2.
Prepare a cross head screw driver.
3.
Read this instruction manual carefully before installation and use. Keep this
instruction manual in a proper and safe place for future use in case needed.
Installation:
1.
Unpack and take out both upper body and lower body together.
2.
Put Lower Body up-side-down (Fig. A). Fix Base cover (#3) onto Lower Control
Box. Then slide Base Cover (#3) , Base (#7) and Washer (#6) onto Base Bracket
(#8) respectively, and fix it well with Screw M6*20 (#5)
3.
Lay Lower Body vertically (Fig. B). Put Upper Body on top of Lower Body. Get
the plug (#2) and power supply cord (#10) through the holes on the center of
Base Cover (#3) and Base (#7). Clip the power supply cord (#10) with Cord Clip
(#11) and fix it onto Base (#7) with Screw (#1) (Fig C).
4.
Fix Upper Body and Lower Body with Joint Boards and Screw M6*27 (Fig.D).
15
EN
Publicité
