Compatibility List; The Kit Includes; Tools Required - XZENT ARGO Serie Instructions De Montage

COMPATIBILITY LIST

Model Model Version
FORD Transit BASIC (MY2019.75)
FORD Transit TREND (MY2019.75)
CAUTION
- T he installation of the XZENT system should be carried out by an authorized installer. Specific knowledge and tools are required to do the installation. Incor-
rect installation can cause damage to the vehicle and the XZENT system.
- C orrect functioning can only be guaranteed when you use the XZENT original accessories included in the kit or optionally available. The XZENT system and the
original accessories must under no circumstance be modified or altered in any way. Inappropriate actions can cause damage to the vehicle and the XZENT system.
NOTE
- T he target vehicle must be equipped with the (Panasonic) 1-DIN DAB/FM OE radio. The XZENT system is not compatible with vehicles that are equipped with
an ex works OE navigation system.
- T his device installation manual applies to vehicle platforms appearing in the above compatibility list, and in a condition as offered by the respective vehicle
manufacturer. Deviating equipment and specific adjustments to battery-, charging systems and power harness layout implemented by the given motorhome
manufacturer brand are not taken into account in these installation instructions. If you have questions or vehicle-specific problems please contact the rele-
vant motorhome manufacturer.
- T he DAB+ and FM tuners are connected directly to the original rod antenna of the vehicle using the antenna cable adaptor included in the set content. For
vehicles that are not listed in the compatibility list above, a suitable DAB/FM roof antenna to be connected to the XZENT system may be required, which is
not included in the scope of delivery.
- T he original multifunction steering wheel controls of compatible vehicle models are supported by the XZENT system. No further accessories are required.
- S oftware updates to the XZENT system are installed with a USB memory device. Therefore make sure when fitting the system, that the USB connection of the
XZENT system is accessible later on (by installation of the USB extension cable).
- I f you have questions or problems relating to the XZENT system, please contact the dealer from whom you purchased the device.

THE KIT INCLUDES

No. Item
1 XZENT X-F280 device
2 IR remote control
3 Release keys for 1-DIN OE device
4 Rubber piece with MX thread for device backside
5 24PIN adaptor cable for cam power + video-in
6 USB-A adaptor cable to FORD Transit USB port in dash-board
7 Microphone with 3 m extension cable and 3.5 mm jack
8 Main wire harness to FORD Transit
9 USB(2) adator cable for lower port with 80 cm length
10 GPS-antenna with 90° angled connector and 3m cable extension
11 Doublesided 3M self-adhesive pad for GPS antenna
12 Main device manual for X-F280
13 CAN-Bus Interface HX-F280CB
14 Antenna adaptor cable FAKRA to FAKRA / SMB

TOOLS REQUIRED

- Torx screwdriver T25
- Release tool contained in accessory set
- Fabric tape
FORD TRANSIT
Model Year
as of 2019
as of 2019
Qty
1
1
1
1
1
1
1
1
1
1
1
1
1
1