Setting The Master Code - hjh OFFICE COMPACT Mode D'emploi

CLOSING DOOR
• Turn the circular handle clockwise to close the door.
AUTOMATIC LOCK
• Three continuously wrong entries will activate the auto lock system and the alarm will beep.
CAUTION: The keypad would be disabled during the beeping. You can only stop the beeps by ope-
ning the safe with emergency key and power-cut by removing the battery.
SETTING THE USER CODE
• With the door open, press the reset button once. The screen shows "_ _ _ _ ".
• Input new code (3-8 digits), and press "LOCK" button to confirm.
• The screen will show "-Into-", and then the new user code will show again, the resetting is
accepted.
• Press "CLEAR" to delete the last number when setting the new user code.
• If the setting is not finished and no action over 10 seconds, the setting mode will exit and the
new code is not accepted.

SETTING THE MASTER CODE

• Open the door.
• Press "0" twice, then press reset button once. The screen will show "_ _ _ _ ".
• Press your new code (3-8 digits), and press "LOCK" button to confirm, the screen will show
"-Into-", which indicates the acceptance and storage of the new code.
• Press "CLEAR" to delete the last number when setting the new user code.
• If the setting is not finished and no action over 10 seconds, the setting mode will exit and the
new code is not accepted.
OPENING THE SAFE WITH THE EMERGENCY KEY
Upon first receipt of the safe, or either the electronic circuit malfunction or codes unknown. You
could also use the emergency key to open the safe.
• Remove the cover of the emergency lock.
• Insert the emergency key, turn it counterclockwise then turn the circular handle clockwise to
open the door.
EN
4