REV Ritter SA-MC08-N04-D Manuel D'utilisation page 7

Safety Instructions for batteries:
• Incorrect polarity of the batteries can destroy the unit.
• Do not store batteries within reach of children, especially those that can be
swallowed.
• Do not attempt to reactivate batteries by heating or similar measures.
• Primary batteries must not be charged as this can lead to electrolyte leakage,
explosion or fire.
• Do not immerse batteries in water and store them in a dry and cool place, not in a
damp place.
• Do not throw batteries into the fire, do not open them or solder or weld them
yourself.
• Do not short-circuit batteries.
Function
The blue indicator lights up when the two parts of the window contact are more
than 1cm apart. The sensor is triggered and sends a signal to the receiver (gong),
which indicates receipt of the signal by a ringtone.
Set up
Open the battery compartment of the window contact. Remove the insulating
strip in the battery compartment. Then close the battery compartment again.
Changing the batteries
Under normal conditions, the blue indicator blinks once, when the sensor is trig-
gered. If the battery status is low, the blue indicator blinks an additional 2 times
quickly after the normal blinking.
To change the batteries, remove the assembly fixture on the rear side. Unscrew
the cover on the battery compartment. Replace the battery with a new battery of
the same type (refer to "Technical Specifications"). The positive pole is pointing
upwards. Then, close the battery compartment again.
10
Creating/deleting coding
Prior to coding, you require a receiver (chime) of the series Orchestra, refer to
"Compatible Products".
Coding the chime and motion detector:
1. Before coding, select your preferable bell tone (refer to "Volume setting/
Melody selection").
2. Remove the battery from the motion detector.
3. Press the "Volume" button on the chime for 5 seconds. You will hear a
ding-dong and the LED starts blinking, to signalise that the coding mode is
active.
Note:
• The coding mode is automatically terminated after concluding the coding.
• The coding mode is only active for 5 seconds.
• The coding mode is always only available for one receiver (chime) and transmitter
(bell push, motion detector, window contact) simultaneously. Repeat the above-
mentioned coding if you would like to code multiple receivers/transmitters.
• You can assign a different bell tone to each transmitter when coding and in doing so,
create a call differentiation.
• Up to 20 receivers (chime) can be assigned to one transmitter (bell push, motion
detector, window contact). Refer to "Compatible Products".
• Up to 20 transmitters (bell pushes, motion sensors, window contacts)
can be assigned to one receiver (chime). Refer to "Compatible Products".
Deleting the coding:
Press the "Melody forward" button for 5 seconds, to reset the chime to the
factory settings. When the chime plays back ding-dong and the LED blinks,
resetting was successful.
Note: The coding between chime and window contact exists, until you delete the
coding as described above. Even if you remove the batteries.
11