Replacement Parts; Battery Replacement; Assembly Procedure For Seals; Technical Service - Campbell Hausfeld CHN70500 Instructions D'utilisation Et Manuel De Pièces

Operating Instructions and Parts Manual
Maintenance (Continued)

rePlACeMeNt PArts

Use only genuine Campbell Hausfeld service parts. Tool performance,
safety and durability could be reduced if improper parts are used. When
ordering replacement parts, specify by part number.

BAttery rePlACeMeNt

Always disconnect the tool from the power source when unattended,
performing any maintenance or repair, clearing a jam, loading,
unloading , or moving the tool to a new location.
The electronics on the tool (low nail indicator lights and nail placement laser pointer)
run off of two (2) AAA batteries located in the compartment on the back of the
magazine. When the batteries' power is running low and they need to be replaced,
the electronic functions may not work properly or at all. Disconnect the tool from air
source and remove the battery compartment cover by squeezing the locking tab and
pulling out. Insert two (2) new batteries in the proper orientation. Do not mix old and
new batteries. Close cover.

AsseMBly ProCedure For seAls

When repairing a nailer, the internal parts must be cleaned and lubricated. Parker O-
lube or equivalent must be used on all o-rings. Each o-ring must be coated with O-lube
before assembling. A small amount of oil must be used on all moving surfaces and
pivots.

teCHNICAl servICe

For information regarding the operation or repair of this product, please call 1-800-
543-6400.

FAsteNer INterCHANge INForMAtIoN

Fasteners used in the Campbell Hausfeld CHN70500 Angle Finish Nailer will also work
in the following brand units:
• Campbell Hausfeld NB3565
• Senco SFN2B, SFN1 and SFN40
• Craftsman 18177

FAsteNers

The following Campbell Hausfeld brad nails are available at local retail stores. For help locating any item,
call customer service at 1-800-543-6400. Campbell Hausfeld nails meet or exceed ASTM Standard F1667.
Model # Length
FB003060 1-1/4 inch
FB004060 1-1/2 inch
FB004560 1-3/4 inch
FB005060 2 inch
FB006560 2-1/2 inch
FB160025 1 inch
FB160040 1-1/2 inch
FB160050 2 inch
FB160065 2-1/2 inch
16
www.chpower.com
• Porter Cable DA250
• Ridgid R250AFA
• Campbell Hausfeld NB0064
Shank Gauge Finish
16 Gauge Galvanized
16 Gauge Galvanized
16 Gauge Galvanized
16 Gauge Galvanized
16 Gauge Galvanized
16 Gauge Galvanized
16 Gauge Galvanized
16 Gauge Galvanized
16 Gauge Galvanized
Figure 25 - Battery replacement
Head Collation Nails Per Stick
Brad Adhesive
Brad Adhesive
Brad Adhesive
Brad Adhesive
Brad Adhesive
Brad Adhesive
Brad Adhesive
Brad Adhesive
Brad Adhesive
CHN70500
Nails Per Box
50 2500
50 2500
50 2500
50 2500
50 2500
50 1000
50 1000
50 1000
50 1000