Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Fig. 9
Crank
rod
connector
Lower chute
crank
5. Slide the upper chute crank through the rubber ring
located on the middle frame (Fig. 10).
Fig. 10
Rubber ring
6. Slide the upper chute crank into the crank rod connector
(Fig. 11).
Fig. 11
Crank rod
connector
7. Align the screw holes and tighten the thumbscrew by hand
(Fig. 12).
Thumbscrew
Upper chute crank
Upper chute
crank
Fig. 12
Thumbscrew
Operation
NOTE: Before using this machine, make sure that the power
source you will use complies with the specifications detailed
in this manual. Before inserting the plug into the socket, verify
that the snow thrower's auger and rubber plates are firmly
secured with screws, and that the rubber plates are facing the
correct direction. Perform a test run to ensure that the rotor
turns freely.
Securing the Extension Cord
1. For safe and efficient use of your snow thrower, use only
a UL-rated extension cord recommended for outdoor use.
Refer to the Extension Cord Chart on page 2.
2. Push the loop of the extension cord through the slot from
the opposite side of the restraint hook. Position the loop
over the hook and pull the cable back through the slot
(Fig. 13).
Fig. 13
3. Insert the female end of the extension cord into the
appliance's polarized male plug (Fig. 14).
9
Extension cord
restraint hook
Extension cord
Publicité
Table des Matières
