Installation And Connection; Before You Begin - D-Link DES-1018MP Guide D'installation Rapide

Link/Act/Speed
Green
10/100 Mbps Ports
(Ports 1 to 16)
Off
Green
PoE
(Ports1 to 16)
Red
Off

Installation and Connection

This section describes how to install a
DES-1018MP in a standard 19-inch equipment
rack and how to connect cables and power to
the device.

Before You Begin

Observe the following precautions to help
prevent shutdowns, equipment failures, and
injuries:
When there
is a secure
connection (or
Solid
link) to 10/100
light
Mbps Ethernet
device at any
of the ports.
When there is
reception or
transmission of
Blinking
data occurring
at 10/100
Mbps.
Off No link
The port is
successfully
connected
Solid to a PoE
light device and
is powering
the device
properly.
The PoE port
has failed,
possibly due
to:
1. PoE total
power budget
shortage
2. Over
current:
Exceeds the
Solid
power current
light
of powered
device's
classification.
3. Short circuit:
An intentional
short circuit
has been
performed on
a powered
device.
No connection
Off to a PoE
device
• Install the DES-1018MP in a cool and dry
place. Refer to the Technical Specifications
for the acceptable operating temperature
and humidity ranges.
• Install the Switch in a site free from strong
electromagnetic source, vibration, dust,
and direct sunlight.
• Leave at least 10 cm of space at the left and
right-hand side of the Switch for ventilation.
• Visually inspect the power jack and make
sure that it is fully secured to the power
cord.
• Do not stack any device on top of the Switch.
Step 1 – Unpacking
Open the shipping carton and carefully unpack
its contents. Please consult the following packing
list to make sure that all items are present and
undamaged. If any item is missing or damaged,
please contact your local D-Link reseller for a
replacement.
Package Contents
DES-1018MP Switch
Power Cord
Power Cord Retainer
Rack Mount Kit and Rubber Feet
Quick Installation Guide
Step 2 – Installation
You can mount the DES-1018MP into a
standard 19-inch equipment rack. To install
the DES-1018MP into a rack:
1. Attach the mounting brackets to each side
of the chassis as shown in Figure 3 and
secure them with the screws provided.
Figure 3. Mounting Brackets
1
1
1
1
1
3