Jet JWL-1442 Mode D'emploi page 7

Use a wood dowel, or aluminium
stock to knock spindle towards the
tailstock. (Use a material that is softer
than the spindle so you do not
mushroom end of spindle).
Go only far enough to remove right
hand pulley and belt from spindle
when changing the belt (Fig 23).
Fig 23
To reassemble reverse the procedure.
Note:
Mark key way on the pulley for easy
reference.
When reinstalling clamping nut,
thread it on to the spindle until its
snug. Then back off slightly and
tighten the socket head cap screw.
9. Trouble shooting
Motor doesn't start
*No electricity-
check mains and fuse.
*Defective switch, motor or cord-
consult an electrician.
Machine vibrates excessively
*Stand on uneven floor-
adjust stand for even support.
*Workpiece is not properly centred-
*The speed is too high-
10. Environmental protection
Protect the environment.
Your appliance contains valuable
materials which can be recovered or
recycled. Please leave it at a
specialized institution.
11. Available accessories
Stock number 708345
Tool basket
Stock number 708330
Spur drive centre MT2
Stock number 708331
Live centre MT2
Stock number 708337
Dead cup centre MT2
Stock number 708332
Face shield
Stock number 709008
8 piece carbon steel wood turning
chisel set
Refer to the JET-Pricelist
for various tools and work holding.
9