Rowenta Compact Steam Pro VR8324 Mode D'emploi page 6

Problem Possible Causes
Water runs out You are using steam
of the holes of for the first time or
the soleplate. you have not used it
for some time.
The setting is not
correct (1 dot /
2 dots) and the
soleplate is not hot
enough to produce
steam.
You are performing
the Anti Calc
procedure
Water streaks Your ironing board is
appear on the saturated with water
linen. because it is not
suitable for use with
an appliance.
Brown streaks You are using
come through chemical descaling
the holes in agents or additives
the soleplate in the water ironing.
and stain the
linen.
Solutions
Press the steam control
button on, pointing the
iron away from your
ironing board until the
iron produces steam.
Set the iron at 3 dots
(••• or MAX) and wait
for the iron thermostat
light to go out before
activating the steam
button again.
It is normal that
water runs out of
the soleplate while
performing the Anti
Calc procedure
Check that your ironing
board is suitable. We
recommend that you
use a vented/mesh
type ironing board.
Never add this type of
product in the water
tank (see "for what
water may be used").
Contact an Approved
Service Centre.
10
Problem Possible Causes
The soleplate is You are ironing
dirty or brown at too high a
and may stain temperature.
the linen.
The "anti calc" The Anti Calc
indicator is procedure must be
flashing.* performed.
The anti calc You have not
indicator is still pressed the Anti
flashing. Calc button.
The anti calc The anti calc
indicator is still procedure has not
flashing after been correctly done.
performing
Anti calc
procedure.
* Depending on the model
If you have any problems or queries please call our Customer
Relations team first for expert help and advice
Solutions
See our
recommendations
regarding temperature
control setting.
See section 2.1
"Maintenance"
Press the Anti Calc
button until the light
stops flashing.
See section 2.1
"Maintenance" to
perform correctly the
anti calc procedure".
11