Snapper HD HT48K Guide D'utilisation page 13

OPERATION
USING THE ROTATING REAR HANDLE (See Figure 4.)
1. Place the hedge trimmer on a flat and even surface.
2. Make sure that you released the trigger.
3. Pull the rotating handle release (1) and begin turning the rear handle.
Release the rotating handle release and turn the handle 90 degrees to
either side until it clicks into place and the lever locks in.
4. To turn the handle back to center, pull the rotating handle release again,
turn the handle slightly, release the rotating handle release and continue
turning the handle until it locks into place.
1
13
FIG.4